Rotating Equipment Maintenance Training (Pumps, Compressors & Turbines)
Pumps, compressors, and turbines are the machines that actually move product through a facility, and when one of them fails unexpectedly, the disruption rarely stays contained to that single piece of equipment. Burraq Consulting’s course builds the maintenance engineering foundation that keeps rotating equipment running reliably, rather than reacting to failures after they’ve already cost production time.
What Is Rotating Equipment Maintenance?
Rotating equipment maintenance covers the inspection, maintenance, and troubleshooting practices applied to centrifugal and reciprocating pumps, compressors, and turbines — the machines responsible for moving and pressurizing fluids throughout an oil and gas facility. Effective maintenance depends on understanding each machine type’s common failure modes, applying the right maintenance strategy, and recognizing early warning signs before a failure becomes a shutdown.
Who Should Attend
- Mechanical engineers responsible for rotating equipment reliability
- Maintenance technicians performing hands-on inspection and repair work
- Reliability engineers building maintenance strategies around rotating assets
Prerequisites
A basic mechanical engineering background is recommended.
What the Course Covers
- Centrifugal and reciprocating pump fundamentals, including common failure modes such as cavitation, seal failure, and bearing wear
- Compressor types and maintenance considerations — centrifugal, reciprocating, and screw compressors
- Turbine maintenance basics, covering common issues in steam and gas turbine systems used in oil and gas facilities
- Bearing and seal technology, and how correct selection and installation prevent premature failure
- Alignment and balancing fundamentals, and why they matter more than many maintenance programs treat them
- Maintenance strategy selection — when time-based, condition-based, or run-to-failure approaches make sense for different equipment criticality
- Root cause analysis for rotating equipment failures, and how findings should change future maintenance planning
Course at a Glance
Why Train with Burraq Consulting
Burraq Consulting’s instructors bring direct rotating equipment maintenance experience from facilities across the region, and this course is grounded in the failure patterns participants will actually encounter — a seal that keeps failing prematurely for reasons the maintenance log never captured, a bearing replacement that treats the symptom instead of the misalignment causing it.
Certification and Next Steps
This course builds practical rotating equipment maintenance competency. It pairs naturally with Burraq Consulting’s Vibration Analysis & Condition Monitoring and Reliability-Centered Maintenance (RCM) courses for a complete maintenance engineering skill set.
Frequently Asked Questions
Seal failure and cavitation are among the most frequently seen issues, often traced back to operating conditions outside the pump’s intended range or inadequate maintenance of suction conditions. The course covers how to recognize and address both.
The course focuses on maintenance principles and failure modes that apply across manufacturers rather than brand-specific procedures, so the knowledge transfers regardless of which equipment your facility runs.
This course covers the equipment and failure mode fundamentals; Burraq Consulting’s Vibration Analysis & Condition Monitoring course goes deeper into the diagnostic technique used to detect many of these failures before they progress. The two work well together.
Yes. The course is designed to be accessible to experienced maintenance technicians as well as engineers, with content pitched at a practical, applied level throughout.
Keep your pumps, compressors, and turbines running when it counts.
or contact us to arrange an in-house program for your maintenance team.